Deactivate Setting Aid - Reer PI SQ NF Notice D'utilisation

0
Signal
Power
1: close zone
2: enable zone

8.3 Deactivate setting aid

0
1: close zone
2: enable zone
45
Signal Signal
Power Power
45 mm
< 2 s
Signal
Power
> 2 s
Signal
Power
As soon as the target enters the en-
able zone, the yellow LED goes out.
If the target is just outside the enable
zone in either direction the LED
starts to flash again.
mm
If the sensor is undamped for more
than 2 s (> 45 mm), the setting aid
is switched off and the yellow LED
goes out.
This can also be achieved by power
off.
UK
11