senya WTF-99G-2 Notice D'utilisation page 12

1. Use:
 Choose the cone which corresponds to the desired use.
 Fit the cone holder (5) on the motor unit (4) by giving it a quarter turn to the
left.
 Place the chosen cone into the opening at the front of the cone holder (5). The cone should be
correctly positioned all the way into the drive.
 Place the splash guard (6) on the cone holder (5) to avoid splashes from tiny foods.
 Place a container under the cone holder (5) to collect the grated or sliced foods. Use a fairly large
container to avoid splattering.
 Plug in the appliance.
 Press the On/Off button (3) to start using the appliance. To run the appliance continuously, hold this
button down.
 ATTENTION: Do not use continuously more than 2 minutes and operating breaks must last at
least 2 minutes. No more than 5 cycles before an about 20 minutes break.
 Insert the food through the feed tube (2) and push the food down using the pusher (1)
 To remove or change the cone, release the on/off button (3) and unplug the appliance. Remove the
splash guard (6). Remove the cone from the drive by turning it a quarter to the right.
Attention :
 Be sure to position the pusher (1) into the feed tube (2) as shown on the side picture
to avoid damaging them.
 The ingredients you use must be firm to get satisfactory results and avoid
accumulation of food in the cone holder (5).
 Cut the food to make it easier to feed through the feed tube (2) from the cone holder
(5).
 Do not use the appliance to grate or slice food that is too hard or frozen or pieces of
meat.
ADVICE FOR CARE & STORAGE
 Always unplug the appliance and wait for its complete stop before dismantling it.
 Never immerse the motor unit, its power cord or its plug in water or any other liquid. Clean them
with a soft, damp cloth.
 Be very careful not to cut yourself when handling the blades since they are sharp!
 Be careful not to drop water inside the motor unit.
 Never use abrasive detergents or scouring pads for cleaning.
 Wipe the external surfaces of the motor unit with a soft, clean cloth.
 All the accessories can be cleaned with a soft sponge, warm water and washing up liquid. Rinse with
clean water and dry thoroughly with a soft cloth. They can also be washed in the dishwasher.
 WARNING: The cone blades are extremely sharp. Handle the cones carefully, always holding
them by the plastic part.
 If necessary, wipe with a soft dry cloth the powercord to remove food residues.
 Do not store the unit near heated sources (eg. Fire, radiators, fan heaters or other heat-emitting
devices).
12