Connections And Installation; Connecting The Control Unit / Connecting The Power Plug And Earth Ground; Installation - Panasonic Technics SP-10R Manuel D'utilisation

Connections and installation

z Turn off all units and disconnect the AC power supply cord from the outlet before making any
connections.
z Connect the AC power supply cord only after all other connections are completed.
z Refer also to the instruction manual of the connected device.

Connecting the control unit / Connecting the power plug and earth ground

1
Connect the control unit
connection cable by inserting it
until it clicks into place.
2
Connect the AC mains lead.
Back of main unit
Earth terminal*
Control unit connection cable
* When necessary, connect the earth terminal of the main unit to that on the amplifier by using a
commercially available earth lead.
Note
z Although the AC power switch is in the "OFF" position, the unit is not completely disconnected
from the mains. Remove the plug from the main electrical outlet if you will not be using the unit for
an extended period of time. Place the unit so the plug can be easily removed.
16
(16)
English
3
Connect the power plug and
earth ground.
z Confirm the wattage of the AC outlet on
the connected equipment before using it
for this unit.
(This unit consumes 10 W.)
Back of Control unit
To a household
mains socket
1
2
AC mains lead

Installation

Notes for installation
„
z Always use two people or more to install or move the unit.
z Before you move the unit, remove all devices connected and turn off the power supply.
Moving the unit with the control unit connected may make it fall off and cause injury.
z Ensure the unit is not exposed to direct sunlight, dust, humidity, and heat from a heating
appliance.
z This unit may pick up interference from a radio if there is one nearby.
Keep the unit as far as possible from a radio.
z Do not install the unit on a heat source.
z Avoid a place with large temperature variations.
z Avoid a place with frequent condensation.
z If anti-tip measures are required, consult a contractor.
The floor and wall strength need to be checked.
z Avoid an unstable place.
z Do not put an object on the unit.
z Do not install the unit in a confined space such as a book shelf.
z Install the unit at a position well away from walls or other devices to ensure effective heat radiation
from the inside of the unit.
z Make sure the installation location is sufficiently strong to withstand the total weight of the unit
and system.
z Note that the unit may be damaged by cigarette smoke or moisture from an ultrasonic humidifier.
Condensation
„
Think of taking out a cold bottle from a refrigerator. If you leave it in a room for a while, dewdrops will
form on the bottle surface.
This phenomenon is called "condensation".
z Conditions causing condensation
 Rapid temperature change (caused by moving from a warm place to a cold place or vice versa,
rapid cooling or heating, or direct exposure to cooled air)
 High humidity in a room with much steam, etc.
 Rainy season
z Condensation may damage the unit. If it has occurred, turn the unit off and leave it until it adapts
to the ambient temperature (approximately 2 to 3 hours).
17
(17)
English