Ahrend 22 Mode D'emploi page 32

3
5
Workstations with hinged cable
trays
Lift the cable tray slightly, pull
forward and open. When work is
finished, close cable tray and push
back under the table.
English
4
Workstations with hinged cable
dumps
It may sometimes be necessary to
wheel a mobile drawer pedestal out
of the way first.
The cable dumps under freestanding
tables open towards the front of the
table.
Leading cables along the edge of the work surface
Equipment cables are led around the edge of the work
surface and fed straight into cable trays or cable dumps
(fig. 3).
If required, cables can also be pushed into cable guides on
the underside of the top so that they are held by the hooks
and do not dangle (fig. 4).
Organizing and separating cables in dumps
The cables in hinged cable dumps can be organized with
blue cable separators, which click into the bottom of the
dump (fig. 5).
The cable dumps under tables that
are placed against a wall or against
each other open towards the side of
the table at which people sit.
They can then be reached under the
work surface.
The cable dump is opened by simul-
taneously pulling out the knobs at
the two opposite ends, on the side of
the dump nearest to you.
The dump will then drop open.
Caution! If all four knobs are pulled
out, the whole cable dump will come
out of the suspension brackets!
Remove any cable dump clamps
used to retain the cables in the
dump.
After the necessary changes have
been made, the cable dump is
closed again. Make sure that the
cable clamps have been replaced
and that the knobs on each side
click back into place.
31