Keep Warm Function; Quick Start - Trebs Comforttemp 99270 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2 Operation
1. Place the machine on a flat surface.
2. Opening the Lid. Press the (2) button. The opener springs open. You can remove the lid by pulling
upwards.
3. Then fill in the water (max. 1.7 Liter). You can read the filling level on the water level indicator of
the kettle.
4. In order to close the lid, press the (2) button. The lid must audibly lock into place.
5. Place the kettle lush on the base.
5.3 Operation
1. Select a temperature using the buttons 6 to 10.
2. Press the button. The light on the button will light up.
PLEASE NOTE
The light on the temperature button flashes whilst the water heats up.
If the temperature has been reached, you hear two buzzers.
The light on the button turns of.
The light on the temperature button lights up until you take the jug from the base.

5.4 Keep warm function

You can keep the water hot for half an hour at the following temperatures: 70°C, 80°C
and 90°C.
To do this, press the
The light on the
Then press the
The keep warm will remain active, even if you take the jug from the base for up to a minute.
The keep warm function cannot be used for 100 °C.

5.5 Quick start:

Press the
button after putting the jug onto boil.
The water will be heated to 100°C.
5.6 Ending/Terminating operation
There are three options for ending/terminating the boiling process:
The appliance will switch off after the boiling process.
You can press the
Take the jug from the base. The light on the
WARNING
Danger of scalding
When pouring the water out, keep the lid closed.
During operation the housing becomes hot. Do not touch it and allow the device to cool
down before storing it away.
Remove the mains plug.
Emptying the water container.
button after you have selected a temperature.
button lights up.
On/ Off button
button again in order to end the boiling process.
button will go out.
28

Publicité

Table des Matières
loading

Table des Matières