HumanTechnik Sonumaxx A-4035-0 Mode D'emploi page 13

Connecting headphones / the tele loop
Headphones or a tele loop equipped with a 3.5mm stereo cinch plug can be connected to
the jack at the reciever.
15
Headphones and tele loops are sold separately.
Using the receiver
- Use the volume control
ing. Turn the volume control in the direction of the "6" to increase the volume and in the
direction of the "0" to decrease the volume.
- Use the sliding switch
setting: "ON"). The red LED
switched on. Make sure that the sound source connected is switched on and adjust the
volume on the receiver to a level that is comfortable for you.
- Use the tone control button
Turn the tone control button upwards to amplify high tones and down to amplify
low tones.
- Use the balance control button
balance. Set the balance so that you hear equally well with both ears.
Battery recharging contacts
- We recommend that you keep the battery contacts
tery can always recharge properly and fully (using the recharging contacts in the recharg-
ing tray of the transmitter and the recharging contacts on the receiver).
Replacing the battery
- If it becomes necessary to replace the rechargeable batteries after you have used the
receiver for a considerable time, please have this done by the specialist from whom you
purchased the device.
Warranty
This product is very safe to operate and provides highly reliable service. Should a malfunc-
tion occur despite the unit having been set up and operated correctly, please contact your
dealer. This warranty covers the repair of the product and returning it to you free of charge.
It is essential that you send in the product in its original packaging, so do not throw away the
packaging. The warranty does not apply to damage caused by incorrect handling or attempts
to repair the unit by people not authorised to do so (destruction of the seal on the unit).
Repairs will only be carried out under warranty if the complete warranty card is returned
accompanied by a copy of the dealer's invoice/till receipt. Always specify the product
number in any event.
to initially set the receiver to a low volume to protect your hear-
9
, on the left-hand side of the receiver to switch it on (switch
10
will light up to indicate that the receiver has been
11
on the right-hand side of the receiver to adjust the tone.
12
on the rear side of the receiver to adjust the volume
14
clean at all times so that the bat-
13
English 13