PNI MAB300 Manuel Utilisateur page 16

lights continuously until the door closes (~ 30s), then goes out. "1" - alarm
in a monostable way, the lamp will only flash when the gate is in operation.
"2" - the alarm is on a bistable model and the lamp lights continuously until
the gate closes (~ 30s), then goes out. "3" - the alarm is on a bistable model
and the lamp will flash only when the gate is in operation. After choosing the
value, press the FUN button to save the data (factory setting 0).
8. Setting the lock time (Pb)
There are optional levels from 0 to 1. "0" means that the blocking time is
0.5s. "1" means that the locking time is 5s. After choosing the value, press
the FUN button to save the data (factory setting 0).
9. Setting the single or double gate (PC)
There are optional levels 0 - 3. "0" means that the gate cannot be opened by
the remote control. "1" means that the gate opens only unilaterally. "2" means
that the door opens with both doors. "3" means that the door is opened both
individually and with both doors. After choosing the value, press the FUN
button to save (factory setting 3).
10. Setting the photocell working mode NC or NO
Pd appears on the screen. The value 00 means the NO mode, and the value
01 means the NC mode.
11. Reset (Po)
Factory data reset.
After choosing the value, press the FUN button to save the data.
User manual 16