Dirna 12 V Manuel De L'utilisateur page 12

EN
The unit marks the temperature inside the vehicle. In this operation mode the unit is off.
In function F2, push key
from 1H to 9H, and then push the ON/OFF
F0. The unit will work the selected time.
F3 Function: Low consumption module (stand-by)
If the unit does not start up in 6 to 8 days, it goes into stand-by. Manually press the
ON/OFF key
To activate this function, keep the ON/OFF
F6, and then release the key to directly enable ºF. To return to ºC, keep the
control panel pressed down with the display flashing C
press the
operation, meaning it must be registered again once finished.
!
If the battery gives out continuous beeps when connected, the belt is disconnected or poorly
connected.
E0 - Recirculation gauge failure
E1 - Low battery
E2 - Blower or electrofan failure
E3 - Compressor failure
(Causes: motor, cabling, connector,
insufficient or excess load)
F1 Function: Digital thermometer module
F2 Function: Time programming
or
to reactivate the unit.
F6 Function: ºF Selection
key on the control panel. The control is disabled when carrying out this
from the display we choose the programmation time
key and let go of in the wished option F4/
key pressed down until the display shows
Error messages
E5 - Control module heating failure
E6 - Anti-ice gauge failure
E7 - Control
failure
Ec - Communications cable failure
12
key on the
, when it stops flashing,
module communication