VONROC LD502DC Traduction De La Notice Originale page 5

1. SAFETY INSTRUCTIONS
Read the enclosed safety warnings, the additional
safety warnings and the instructions. Failure to
follow the safety warnings and the instructions may
result in electric shock, fi re and/or serious injury.
Save the safety warnings and the instructions for
future reference.
The following symbols are used in the user manual
or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-obser-
vance of the instructions in this manual.
The product is in accordance with the
applicable safety standards in the European
directives.
Risk of eye injury due to laser
LASER
beams! Never look directly into
2
the laser and do not direct the
laser beam towards refl ecting
surfaces!
GENERAL SAFETY WARNINGS
• To operate this device safely, the user must
have read and understood these instructions for
use before using the device for the fi rst time.
• Observe all safety instructions! Failure to do so
may cause harm to you and others.
• Retain all instructions for use, and safety in-
structions for future reference.
• If you sell or pass the device on, you must also
hand over these operating instructions.
• The device must only be used when it functions
properly. If the product or part of the product is
defective, it must be taken out of operation and
disposed of correctly.
• Never use the device in a room where there is a
danger of explosion or in the vicinity of fl amma-
ble liquids or gases.
• Keep children away from the device! Keep the
device out of the way of children and other
unauthorised persons.
WWW.VONROC.COM
Using battery-operated devices
• Only use batteries approved by the manufacturer.
• Danger of fi re! Never charge the batteries.
• Keep batteries away from metal objects that
could cause short circuiting when not in use.
There is a risk of injuries and fi res.
• Fluid can escape from the battery when used
incorrectly. Battery fl uid may result in skin irri-
tations and burns. Avoid contact! In the event of
accidental contact, rinse thoroughly with water.
Immediately seek the aid of a physician in the
event of eye contact.
MACHINE SPECIFIC SAFETY WARNINGS
• The device is intended for using in dry environ-
ment.
• Avoid the infl uence of humidity and dirt as well
as direct sun rays.
• Do not operate the device in the proximity of
welding machines, induction heaters and other
electromagnetic fi elds.
• Do not expose the device to high temperatures
for a longer period of time.
• Symbols appearing on your device may not be
removed or covered. Signs on the device that are
no longer legible must be replaced immediately.
Handling of laser beams
• Do not look directly into the beam, not even
from great distances.
• Never direct the measuring beam towards peo-
ple, other living creatures or refl ecting surfaces.
• Conventional laser glasses do not protect
against the dangers of laser beams. They only
serve for improved recognition of the laser
beam.
Warning - Laser beam
Never look into the light beam
Laser Class 2
according to EN60825-1: 2014;
λ λ : 620-690 nm; P< _ 1mW
2. MACHINE INFORMATION
Intended use
This laser distance meter can be used when requi-
ring the measurement of an area of a room. This
measuring tool is intended for measuring distan-
ces, lengths and heights in a straight line and can
calculate areas and volumes.
EN
5