Operating Instruction - Jilong Z-RAY I Série Manuel D'instructions

INFLATING AND DEFLATING THE BOAT
Assembly of the oar
Assemble the section of the oar by depressing the spring loaded pin and inserting
the sections of oar until the pins lock into their retaining holes.
Installation of oars
Insert the bolt on the swivel oarlock into the central hole on the oar shaft. Screw
the retaining nut onto the end of the bolt and position the oar into the oar holder.
10 www.jilong.com ZBI-13-GB(V1)

OPERATING INSTRUCTION

Preparation before departure
Acquire necessary information and inform other passengers:
1. Get information on local laws, regulation and hazards related to water activities and boat
operation.
2. Check weather forecast, local currents, tides and wind conditions.
3. Advise someone on land of the time you plan to be back.
4. Explain basic boat operation to all passengers.
5. Be sure that at least one of your passengers can operate the boat in case of emergency.
6. Learn how to determine the distance you can cover, and remember that bad weather
conditional can alter this.
Check the working condition of the boat and equipments
1. Check inflation pressure.
2. Check all safety valves.
3. Check the load is evenly distributed on deck of boat: front to back and side to side.
4. Take care for maximum motor power.
Check that required safety equipment is on board
(Check the laws and regulations of the country or locality in
which you're boating)
1. One personal flotation device (PFD) for each passenger.
2. The air pump, oars repair kit and tool kit.
3. The mandatory equipment.
4. The boat papers and your boating license (if applicable).
5. Lights are required if operating after dark.
Rules to observe during navigation
1. Be responsible and strictly follow the safety rules. Do not neglect the safety rules, this
could hazard your life and lives of others.
2. Learn to keep control of your boat.
3. Respect local regulations and practices.
4. Navigate on „sheltered water" only.
11 www.jilong.com ZBI-13-GB(V1)