Hitachi DH 38YE Mode D'emploi page 16

English
4. How to use stopper
(1) Install the stopper (Fig. 7)
1 Loosen the side handle and insert the straight
portion of the stopper into the handle bolt
hole from the front cover.
2 Loosen the side handle, move the stopper to
the specified position and rotate the grip of
the side handle clockwise to fix the stopper.
5. How to use the drill bit (taper shank) and
the taper shank adaptor.
(1) Install drill bit with taper shank in the taper
shank adaptor.
(2) Turn the power on and drill a base hole.
(3) After cleaning out dust with a syringe, attach
the plug to the anchor tip and drive in the
anchor with a manual hammer.
(4) To remove the drill bit with taper shank, insert
a cotter into the slot of the taper shank adaptor,
place supports under the rotary hammer and
tap the cotter with a manual hammer. (Fig. 9)
16
Stopper
Fig. 7
Taper Shank Adaptor
Drill Bit
(Taper shank)
Fig. 8
Taper Shank
Adaptor
Cotter
Support
Fig. 9
Side Handle