Telcoma T201 Mode D'emploi page 70

GB
FINAL TEST AND INSPECTION
- Check correct operation of the protective devices (anti-crushing system, stop pushbutton, photocells, safety
edges, etc.).
- Check correct operation of the control devices (P/P button, remote controls, etc.).
IMPORTANT RECOMMENDATIONS CONCERNING INSTALLATION
- Check that the existing structures (posts, hinges, leaves) are stable in relation to the forces developed by the motor.
- Check that suitably robust limit stops have been installed for end of gate opening and closing.
- Check the state of the cables that are already present in the system.
- Analyse the hazards connected with the automation system and adopt the necessary safety and signalling devices
accordingly.
- Install the commands (e.g. the key selector) so that the user is not placed in a hazardous area when using them.
- Upon completion of the installation, test the safety, signalling and release devices of the automation system several times.
- Give the end user the instructions for use, the safety recommendations and the CE declaration of conformity.
- Ensure that the user has understood the correct automatic, manual and emergency operation of the automation system.
Inform the user in writing (in the use instructions for example):
- Of possible non secluded residual risks and of foreseeable improper use.
- To disconnect the power supply when cleaning the area that is automated or when performing small maintenance
operations (e.g.: repainting).
- To frequently control that no visible damage has occurred to the automation, and to inform the installer immediately
if damage is noticed.
- Not to allow children to play in the vicinity of the automation.
Prepare a maintenance schedule for the automation installation (at least once every 6 months for the safety
devices), recording the work carried out in a special book.
In line with its continual product improvement policy, both in aesthetic and functional terms, TELCOMA Srl
reserves the right to make changes at any time without notice.