Trevi SB 8370 SW Mode D'emploi Et Branchement page 14

ENGLISH
USB INPUT
1. Insert a USB memory into the input (4);
2. Turn ON the unit. The contents of the USB will automatically be played;
3. Press(23) button on the remote control or PLAY (1) button on the unit, to stop playback temporarily. Press
it again to resume playback;
4. Press 9 (15) or : (22) button on the remote control or the PREV/V - (5) or NEXT/V + (6) buttons on the unit
to move to the previous or next track.
AUX-IN
1. Use a 3.5mm Stereo jack cable to connect the AUX input (12) on the back of the sound bar to the headphone/
audio output of the TV or other source device;
2. Turn on the nit; press the MODE button (18) on the remote control or the SOURCE (3) button on the unit and select
the AUX input;
3. For correct sound reproduction refer to the VOLUME ADJUSTMENT AND MUTE FUNCTION chapter.
OPTICAL INPUT
1. Use a digital optical cable (not included) to connect the OPTICAL input (11) to the digital optical output of the TV
or other source device;
2. Turn on the appliance; press the MODE button (18) on the remote control or the SOURCE button (3) on the unit
and select the OPtl input.
Note:
• Before connecting the optical cable, be sure to remove the plug protection cover if your cable is
equipped with it.
• Some TVs or devices is necessary to enable the digital optical output.
• PCM digital audio must be set on the source device for playback from this input.
BLUETOOTH OPERATION
1. Turn on the appliance; press the MODE button (18) on the remote control or the SOURCE button (3) on the unit
and select the BLUETOOTH function;
2. The system will automatically go into pairing mode;
3. Activate the Bluetooth functionality on the external device to be paired;
4. Start the device search. At the end select the "SB 8370 SW" device;
5. Enter the password "0000" if required;
6. Press(23) button on the remote control or the PLAY (1) button on the unit to start playback and the 9 (15)
or : (22) buttons on the remote control or the PREV/V - buttons (5) or NEXT/V + (6) on the unit to select tracks.
EQUALIZER
The sound bar has a pre-set equalizer system, repeatedly press the EQ button (21) during playback to select the
audio dynamic that best suits the music style being played.
Press the 3D button (19) to have a surround effect.
TROUBLESHOOTING
If the Sound Bar does not work properly, check this short list before taking it to a TREVI authorised service centre.
In any case, do not try to repair the device, this will void the warranty. Only TREVI authorised service centres are
authorised to perform operations on this product.
No Sound:
 Check that the MUTE function is not activated.
 Check that the correct input has been selected.
14
SB 8370 SW