Facom E.5000 Notice D'instructions page 6

GB
CHARACTERISTICS
- TORQUE RANGE: 10-1100 N.m
- ACCURACY: ± 1% of the figure read
- UNIT: N.m, daN.m, cN.m, kgf.m, lbf.in, lbf.ft
- IMPERMEABILITY: IP5 (EN 60529)
- CONSUMPTION: use 30-50mA / 230V - on standby 15mA / 230V
- ELECTROMAGNETIC COMPATIBILITY 89/336: CEI EN 50081-1 / CEI EN 50082-2
- TEMPERATURE: storage - 20°C + 70°C / in use 0° to 50°C
- SUPPLY VOLTAGE: 115V - 60Hz / 230V - 50Hz
- SENSITIVITY DRIFT: 0.02% per °C
-
LANGUAGES: FRENCH, ENGLISH, GERMAN, DUTCH, SPANISH, POLISH, PORTUGUESE, DANISH, SWEDISH, ITALIAN
WARNING
- AT THE TIME OF THE FIRST COMMISSIONING, YOU HAVE A CHOICE OF LANGUAGE WITH THE POSSIBILITY OF CHANGING IT IN THE
SETTING MODE DESCRIBED HEREAFTER.
- AFTER 5 MINUTES OF INACTIVITY, THE APPARATUS SWITCHES OFF. SIMPLY PRESS ANY KEY TO ENABLE IT. THIS AUTOMATIC CUT-OFF
FACILITATES THERMAL STABILITY, WITHOUT RISK FOR THE E.5000.
- KEEP THIS APPARATUS CLEAN (Dust, moisture, filings or any other corrosive agent)
- ONLY THE FACOM ADAPTERS MUST BE USED ON THE TORKONTROL E.5000 APPARATUS, EXCLUDING ANY OTHER SYSTEM. THESE SAME
ADAPTERS CANNOT BE USED ON ANOTHER TORQUE TESTER.
- THE PRECISE ADAPTERS / SENSOR ADJUSTMENTS PROHIBITS ANY DEFORMATION AND MAKE. THE CLEANLINESS OF THE ADAPTER/SENSOR
TORQUE IS PROOF OF EFFICIENT AND SUSTAINABLE SERVICE.
- IF THE APPARATUS DOES NOT WORK AS SOON AS IT IS SWITCHED ON, CHECK THE MAINS SUPPLY, THE CABLE AS WELL AS THE FUSE
BEFORE RETURNING THE E.5000 TO AFTER-SALES WHETHER IT BE UNDER GUARANTEE OR NOT.
- THE BATTERY IS NOT INCLUDED IN THE GUARANTEE.
WHILE THE
OK STOP NO
INDICATOR
ON
DISPLAY:
• DISPLAYS TORQUE
• MEASUREMENT, STEADY ZERO,
• ERRORS...
BAR GRAPH
ANALOG
VISUALIZATION
OF TORQUE
WHEN ZERO FLASHES CONTINUOUSLY, A
PRESSING THE R KEY.
WHEN CHANGING THE CONTROL DIRECTION, THE DISPLAY SCREEN
REQUESTS "SCREEN RESET", WHICH MEANS RESET TO ZERO BY
PRESSING THE R KEY.
ZERO IS FLASHING, DO NOT APPLY TORQUE. WAIT UNTIL THE
GREEN: IN TOLERANCE
RED: WITHOUT ADJUSTMENT
OK
INFORMATION REGARDING
MODES: WORK - SETTING - UNIT - ADJUSTMENT - Etc.
RESET MUST BE MADE BY
ZERO STOPS
RED: OUT OF TOLERANCE
STOP NO
RESET to 0
FLASHING
CHOICE OF USE
MODE
VALIDATION
OF CHOICES
SCROLLING
OF
FUNCTIONS