Publicité
Les langues disponibles
Les langues disponibles
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specified
on the type plate of the machine.
Troubleshooting
Fault
Possible cause
The machine does not start Power supply
interrupted
Defective fuse
Defective cable
Defective plug
Higher exertion of force
Cutting blade dull
required while working
Machine automatically
Carbon brushes worn
switches off
Disposal information
Disposal
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
Only for EC countries:
Do not dispose of power
tools into household waste!
According the European
Guideline
2002/96/EC for Waste Electrical
and Electronic Equipment and its
implementation into national right, power
tools that are no longer usable must be
collected separately and disposed of in an
environmentally correct manner.
10/2012 Estrichfugenschneider EF 135, #68679
Subject to change without notice.
Remedy
Contact
electrician
for repair and/or
replace parts
Replace
cutting blade
or resharpen
Contact
electrician
to replace
26
Publicité
