3-Names And Functions - TEAC PROFESSIONAL Tascam VL-A4 Manuel Du Propriétaire

3-NAMES AND FUNCTIONS

0
0
VL-A4
VL-A5
VL-A8
1 ~ IN jack
This ~ IN jack is used to connect the supplied power cord.
2 FUSE holder
This unit is equipped with a fuse. lf the unit does not
work, disconnect the power plug from the AC outlet and
then contact the nearest qualified service personnel.
3 POWER switch
This is used to turn the power on and off.
INPUT jack
4
This is a balanced input terminal that uses an XLR balanced
cable and TRS PHONE balanced cable combination jack.
This INPUT jack connects the unit to an external device.
8
TASCAM VL-A's
Rear Panel
Rear Panel
Rear Panel
5 LEVEL CONTROL knob
This is used to adjust the output volume.
6 POWER indicator (Front Panel/Rear Panel)
This indicator lights up when the power switch is turned
on and AC power is supplied to the ~ IN jack.
7 HF CONT switch (VL-A5, VL-A8 only)
This is used to adjust the treble level.
+
1.5 dB 8k: Boosts the 8 kHz frequency by 1.5 dB.
+1.5 dB 3k: Boosts the 3 kHz frequency by 1.5 dB.
-1.5 dB 8k: Cuts the 8 kHz frequency by 1.5 dB.
-1.5 dB 3k: Cuts the 3 kHz frequency by 1.5 dB.
LF CONT switch (VL-A5, VL-A8 only)
8
This is used to adjust the bass level.
LF+: Boosts the 150 Hz or 800 Hz frequency by 1.5 dB.
LF-: Cuts the 150 Hz or 800 Hz frequency by 1.5 dB.
LF CUT: Cuts bass sounds at a frequency of 500 Hz or lower.
Front Panel
Front Panel
Front Panel