Schumacher Electric 98026071 Guide De L'utilisateur page 10

2.3 SPECIFICATIONS
Input Voltage
Input amps @ rated Output
Input Plug Style
Power cord length
rated Output amps
Max Output amps
rated Output Volts
rated Duty cycle
Max Open circuit Voltage
agency listing
Output Settings
2.4 POWER REQUIREMENTS
WARNING: THIS WELDING MACHINE MUST BE CONNECTED
TO A POWER SOURCE IN ACCORDANCE WITH APPLICABLE
ELECTRICAL CODES.
This welder intermittently draws more than 15 amps of current. We
recommend that you either install a 20 amp circuit or do not run anything
else on the same circuit as the welder or you may trip the breaker
supplying the ac power. If you modify the power cord in any way, other
than attaching the proper input plug, you will void the manufacturer's
warranty. It is recommended that a qualified electrician verify the actual
voltage at the receptacle into which the welder will be plugged and confirm
that the receptacle is properly fused and grounded. The use of the proper
circuit size can eliminate nuisance circuit breaker tripping while welding.
DO nOT OPeraTe THIS WelDer if the actual power source voltage is
less than 100 volts AC or greater than 125 volts AC. Contact a qualified
electrician if this problem exists. Improper performance, damage to the
welder, property damage and/or personal injury can result if operated on
inadequate or excessive power.
WARNING: ELECTRIC SHOCK CAN KILL! FIRE CAN KILL,
INJURE, AND CAUSE PROPERTY DAMAGE!
•
•
To reduce the risk of electric shock and fire, connect only to
properly grounded and fused outlets.
never alter the ac power cord provided on the welder. never
alter an extension cord or extension cord plugs.
120 volt 60 Hz. Single Phase
120 volt 15 amp
7
• •
20 aac
6-ft.
70 AAC
80 aac
27 VAC
10%
40 Vac
culus
2