La Sommeliere CVDE46 Mode D'emploi page 12

the lamp.
•
When disposing your appliance, please choose an authorized disposal site.
Installation of Your Wine Cooler
•
This appliance is designed to be for free standing installation or built-in (fully recessed).
•
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.
•
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
•
Avoid locating the unit in moist areas.
•
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Products service center.
Reversing the Door Swing of Your Appliance
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow these instructions.
.
Note: All parts removed must be saved to do the reinstatement of door.
7. Open the glass door and remove the two screws under the right bottom corner of
the glass door that are used to hold the lower hinge to the glass door. Be careful
to hold the glass door with hands from dropping after removing the screws.
8. Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
12