Rollei Soluna II-60 Mode D'emploi page 24

Operation
24
3. Notes on radio operation
• When using radio remote controls, please note that for correct operation, the radio
channel and group must be set identically on each continuous LED light and on the
remote control .
• Please note that the radio frequency (2 .4 GHz) used by these devices is shared
with other users/devices . Interference cannot be ruled out due to this . If necessary,
change the radio channel to avoid interference .
Notes for use with Rollei radio remote controls
With the Rollei Professional Flash Trigger Mark II you can switch the Rollei
Soluna II-60 LED continuous light on or off or adjust its output .
4. Setting the radio signal
• Briefly press the adjustment knob [9] and the display of the radio signal [13] starts
to flash .
• Make the desired setting (P / 6 / 0) by turning the adjustment knob [9] . Use the
signal P to use your LED continuous light with the Rollei Professional Flash Trigger
Mark II, use the signal 6 to use it with the Rollei Pro U7 Flash Trigger and the signal
0 to switch off the radio signal . By repeatedly pressing the setting knob [9] you can
access channel (0 – 15) [14] and group (A – J) [15] and set them by turning the
adjustment knob [9] . Confirm the settings by pressing the adjustment knob [9] .
5. Adjusting the power
• The output [16] of the LED continuous light can be steplessly adjusted
from 1 to 100% .
• The maximum output is shown in the display [2] as 100% .
ENGLISH