SEVERIN KA 5700 Mode D'emploi page 9

●
Unplug the machine from the mains
supply socket:
- in the event that it malfunctions
during use,
- when it is not in use,
- before cleaning.
●
Do not operate the coffee maker with a
damaged mains lead or after it has been
damaged in any manner.
●
If the supply cord is damaged, it must be
replaced by the manufacturer or its
service agent or similarly qualified
person in order to avoid a hazard.
●
Repairs of electrical appliances should
only be performed by skilled personnel
as safety precautions have to be
observed. Improper repairs can result in
considerable hazards for the user.
Should your coffee maker require
repair, please contact the nearest
authorized Severin service centre.
Addresses are detailed in this booklet.
●
This coffee maker has been designed for
domestic use only and not for
commercial applications.
●
In case the coffee maker is misused or
operated in any manner other than
described in these instructions for use,
no liability will be undertaken for
possible damage.
First use
●
First clean your coffee maker by
operating it twice or three times with
approx. 6 cups of fresh cold water but
without using ground coffee.
●
The Vapotronic-system
automatically switch off the water
reservoir element. It cannot be switched
off manually.
How to make filter coffee
- When making smaller quantities of
coffee, it is better to place the glass jug
on the hotplate and then switch it on. In
that way, the freshly brewed coffee will
be delivered into the pre-heated jug.
- Open the pivoted filter holder (6) and
take off the filter holder lid (5)
(illustration I).
- Place a paper filter (size 1 x 4) into the
plastic filter and add fine ground coffee:
We recommend using
- approx. 6g=2 tsp. for a medium sized
coffee cup and
- approx. 4g=1
coffee cup.
The amount of coffee used may be
altered to taste.
- Replace the filter lid (5) back onto the
filter holder (6) and swing back the filter
holder.
- Open the water reservoir lid (3) and fill
the reservoir (4) with the required
amount of cold water. The minimum
quantity of water used should be for two
medium-sized coffee cups (illustration
II).
- The water level marks inside the water
reservoir help you to measure the
amount of water needed for the number
of cups of coffee you wish to prepare:
- water level marks on the left-hand
side:
medium-sized coffee cups (approx.
125 ml)
- water level marks on the right-hand
side:
smaller sized coffee cups.
●
Be careful not to exceed the maximum
water level of 8 medium-sized cups as
otherwise boiling water may be ejected
and cause burns.
- Close the water reservoir lid (3). This is
important as the "Vapotronic"-system
will can only operate while the lid is closed.
- Place the glass jug (9) with its lid (8) on
top of it onto the hotplate (10). The jug
lid opens the non-drip valve of the filter
holder (illustration III).
- Switch the hotplate (10) on by turning
the on/off switch (1) to ON-position.
Alternatively you can leave the hotplate
switched off during the filtering process
and switch it on only after the filtering
process is complete. This affects the
coffee temperature.
- Switch on the water reservoir element
9
/ . for a smaller sized
1
2