Vox VC-4 Mode D'emploi page 11

Note! If the adjustment doesn't work properly,
then the Bank Display will show "
" . If this happens, try the procedure again
"
starting from the step 3.
b) Re-Calibrating the external volume pedal
1. First, make sure that the power to the Valvetronix
amp is off.
2. If the volume pedal allows for setting a minimum
volume setting, set the value at the minimum.
3. Turn on the power of the Valvetronix amp with
foot switch 3 and the FX ON-OFF/ CHANNEL
button pressed down. Doing this will cause the
Bank Display to show "
" .
"
4. Slowly "open" the external Volume pedal until it
is fully "open".
5. Press the TAP TEMPO switch on the VC-4 and
the Bank Display will show "
6. Slowly press the external Volume pedal down
until it is fully closed as shown below.
TIP! Pressing the FX ON-OFF / CHANNEL
switch terminates the adjustment.
7. Press the TAP TEMPO switch on the VC-4.The
Bank Display will show "
VC-4 will return to normal. When the adjustment
is not properly executed, the Bank Display will
show " and then "
"
procedure again, starting from step 4.
If your problem persists after going through all the
above suggested solutions, please contact your
authorized VOX dealer for further assistance, or
visit www.voxamps.co.uk.
and then
"
for 1 second and then
"
.
"
for 1 second and the
"
". If this happens, try the
Specifications
Bank display: 1
LED: 6
Tuner: 5 LED auto chromatic tuner
Controller: pedal, foot switches 1-4 (ON/OFF
switches for PEDAL, MOD, DELAY, REVERB), TAP
TEMPO switch, FX on/off, Channel & Hold:Bank
button
Connection: Volume jack, VOX BUS jack
Power: Supplied through VOX BUS jack.
Measurement (W x D x H): 417 x 158 x 63 mm /
16.42" x 6.22" x 2.48"
Weight: 1.8 kgs. / 3.97 lbs.
Accessory: 10 Base-T straight Cable category 5
(5 m)
CAUTION: Do NOT use a 10BASE-T cross-
over cable as doing so will damage your
amplifier and void your warranty.
Option: V850 volume pedal
11