Operation With Dolby Digital Decoder; Adjusting The Sound - Loewe Audio AC3 Mode D'emploi

Operation with Dolby Digital Decoder

Adjusting the sound

Installation of the Dolby Digital Decoder extends the sound setting op-
tions. You now call the sound mode with the
Setting the Sound mode
Call Sound mode.
Sound mode
optimal
S elect the number of speakers you want to hear by
pressing several times.
or:
34 Select the number of speakers you want to hear.
You can also enter the number of speakers with the
numeric buttons of the remote control.
Additional sound settings for volume adjustment and for Sound mode:
➠ As long as the volume bar or the speaker selection is
still visible in sound mode:
 Call additional sound settings.
Volume
24
34 Select sound setting,
6 Go to the menu line below.
3 4 Make change.
Sound settings via the TV menu
➠ In normal TV mode, without other displays.
Call TV menu.
3 4 Select Sound,
6 go to the menu line below.
3 4 Select desired sound setting,
6 Go to the menu line below.
3 4 Make change.
- 8
L button.
...
(5) 4 3 2 1
Sound mode DPLII mode Sound adjustment
Explanations of the sound settings:
Sound mode Select number of speakers you want to hear. The selection
depends on the connected sound components and on the
transmitted audio signal.
➠ If the number of speakers appears in brackets, the
sound of missing speakers is transmitted by the availa-
ble speakers (virtual).
optimal
The momentarily reproduced audio signal is output with
the ideal number of speakers.
1
Playback of center sound or mono (left/right).
2
Playback of front sound (L/R stereo).
3
Playback of front and center sound.
4
Playback of front and surround sound.
5
Playback of front, surround and center sound.
Amplifier Play via an external HiFi amplifier. Selection is only
possible if an amplifier has been selected in the sound
components wizard.
Sound
Speech, Classical, Pop, Custom music, and Custom film
adjustment
sound.
Headphone Adjust the headphones volume.
volume
Loudness Proper boost of bass and treble tones at low volume.
Here you can make Dolby Pro Logic II sound settings for
Dolby PLII
movie, music, matrix and personal settings. The menu item
END mode
Headphone volume
only appears with certain sound mode settings.
call with OK.
more ...
Selection possibility Mono/Stereo or Sound  or Sound
Sound
2 for two-sound broadcasts separately for speakers and
Speakers/
Headphones headphones. Only available with analogue stations.
Auto Volume Reduces volume differences, e.g. for advertisements that
are too loud.
AV output Sound selection for two-sound broadcasts.
signal
Maximum Determining the maximum volume that can be set.
volume
Switch on Specify the volume that is set when switching on the TV
volume set with the power switch. This does not affect switching
the set on from standby mode.
Volume The volume can differ according to the individual stations.
adjustment for If the sound is too loud or quiet in relation to other sta-
current station tions, adapt the volume. When the menu is open, you
can select the stations one after another with P+/P– and
adjust every single station conveniently.