PRO Intellect Technology PRO 40 Série Mode D'emploi page 21

System errors. Service.
Code
E-1 Left sensor is either blocked or failed.
Right sensor is either blocked or
E-2
failed.
Tachometer sensor is either dirty or
E-3
failed.
E-4 UV sensor is either blocked or failed.
Sensor in the hopper is blocked by
E-5
the banknotes or is dirty.
Sensor in the stacker is blocked by
E-6
the banknotes or is dirty.
In order to provide the best functioning of the device, it is necessary to comply with the
following simple requirements:
Switch off the device, when not in use
Use protective cover, when not in use
Clean the hopper and stacker with a clean dry cloth. Sensors can cause errors when
dirty.
It is recommended to carry out preventive measures, including partial disassembling of
the counter each 30 days by an engineer in the service center.
Reason Solution
Switch off and then switch on the power, clean
the sensor or contact the service center
Switch off and then switch on the power, clean
the sensor or contact the service center
Contact service centre.
Switch off and then switch on the power, clean
the sensor or contact the service center
Remove banknotes from the hopper, clean or
replace the sensor.
Remove banknotes from the stacker, clean or
replace the sensor.
21