Counterfeit Detection; Counter Operation - PRO Intellect Technology PRO 40 Série Mode D'emploi

6 Counterfeit detection (for PRO 40U model)
UV detection
The UV detector is designed for various currencies and all banknote types. The count-
er automatically tests the banknotes' UV-fluorescence level. If the level is incorrect, the
device stops counting and "EU" error is displayed. Suspicious banknotes will always be
placed on top of the output stack. Such banknote should be verified for authenticity.
Remember that original banknotes accidentally exposed to hostile environment can also
have an incorrect UV-level.
Press "UV" button to switch on the mode. The indicator will light up. The UV detector
functions in any counting operation mode.
7
7.1. Preparation
• Connect the power cord to the device
• Turn power switch (Fig. 1-7) ON
If an error message is shown on the batch mode display as listed in Table 8, contact
service center.
• Counter starts
• When self test mode is finished, the display will read "0" and the counter is ready for
operation
Optical density detection is switched on as default.
7.2. Counting procedure
ATTENTION! To avoid errors in counting, sort banknotes and put aside the following:
with folded edges, well-worn or "washed", dirty, torn.
The PRO 40 series operates differently than similar models. When banknotes are
passed through the device, they are drawn from the top of the stack, not from the bot-
tom. Special attention should be paid to the correct stacking of the banknotes before
attempting any operations.
Banknotes should be placed in the hopper in a neat stack with the first bill facing up.
Banknotes should be placed into the hopper perpendicular to the tray (see Figure 3).
The notes should then be leaned back flat against the tray. Banknotes will be loaded into
the device automatically (see Figure 4).
Wrong banknote position can cause errors, banknotes being ejected from the device,
crumpling or jamming.
-Place banknotes in the hopper
-The counter will count banknotes automatically
-The result will be indicated on the display
-Repeat up to Table 7.2., when necessary
-When counting is finished clear count display results by "START" or "CLR" button
-If an error message occurs, see Table 8

Counter operation

17