Ebode TAKE 6 Guide Utilisateur page 9

4.7 X10 Home Automation Control via IR7243
The TAKE 6 control allows you to command all electric appliances you have in
your house.
Here are some examples that you can do with your 6 in 1 remote using X10:
-Switch on/off , dim lights while you watch TV.
-Switch on the lights at night to frighten intruders when you detect something
suspicious.
-Switch on your electric blanket before the film ends to have it warm when
you go to sleep.
For controlling your lamps or appliances, you will need an IR7243 and
additional X10 home modules. The modules are simply plugged into a/c outlet
with no additional wiring required.
Contact your retailer for additional information.
4.8 The FAV key
The FAV key allows you to program two specific channels and switch between
them with a single key-press. The two channels can be up to 4 key-presses
each and must be a minimum of 2. The first keypress must be a Mode key e.g.
TV with the following keys being up to 3 digits. To program the FAV key :-
a. Press and hold the S (8) button until the LED remains on (occurring after
approximately 2-3 seconds).
b. Release S (8) button.
c. Press and release the FAV (10) key.
d. Press and release desired Mode (4) key (e.g. TV) followed by the 1, 2 or 3
digit keys in the correct order for the first channel selection. The LED will flash
for each keypress.
e. Press and release the FAV (10) key.
f. Repeat Step "d" for the second device channel selection.
g. Press and release the FAV (10) key to store the channel selections. The LED
will turn off and remote returns to normal.
To select between the two channels, press and release the FAV key.
5. Troubleshooting
The remote doesn't work or loses codes entered
• Confirm with your original remote that the equipment works correctly.
• Make sure that you have pressed the corresponding mode key of the
equipment or device that you want to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the
next code of that brand.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 2 CR2032 batteries (new).
• If the LED is lit permanently, in general it will be necessary to replace the
batteries.
• Set the remote back to factory default.
How to set the TAKE 6 Remote back to factory default
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S.
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S.
• Press and release the 0 key (14) once.
• Press and release the S key (8).
• The LED (2) turns off after few seconds.
16-10-2009 9 033000=15299