Table Des Matières; Quick Start Guide - Ebode TAKE 6 Guide Utilisateur

User Guide
General Security Note
Attention:
For carefree and safe use of this product, please read this manual and safety
information carefully and follow the instructions. Technical manipulation of the
product or any changes to the product are forbidden, due to security and
approval issues. Please take care to set up the device correctly - consult your
user guide. Children should use the device only under adult supervision.
Important: the TAKE 6 must be used according the instructions in this manual
and is not suitable for other purposes.
Avoid the following
• strong mechanical wear and tear
• high temperature
• strong vibrations
• high humidity
Please also respect the additional security notes in the various user guide
chapters. To ensure correct set up please read the manual and security notes
carefully.
Battery install and change
The device may only be used with CR02032 batteries - never try to connect to
another power supply. When inserting batteries be sure the right polarity is
used. Remove the batteries when the device is not used for a longer period.
Make sure that the batteries are not short circuited and are not disposed in fire
(danger of explosion). Batteries do not belong in children hands. Don't let
batteries lay around openly - they might be swallowed by children or animals.
If this happens see a doctor immediately.
Disposal of batteries:
Batteries are special waste and do not belong in general household waste
disposal. Leaking or damaged batteries can upon contact with skin cause
burning or acid damage - if necessary use suitable gloves. Please dispose of
batteries in accordance with local bylaws.
Contents
Quick Start Guide
1. Introduction
2. Insert the batteries
3. Function of the remote's buttons
4. Programming
4.1. Manual code entry
4.2. Automatic code search for some well-known brands
4.3. Automatic code search for all brands
4.4. Manual code search
4.5. Identifying codes found
4.6. Volume Control Punch Through
4.7. X10 Home Automation Control via IR7243
4.8 The FAV key
5. Troubleshooting
6. Tips & Tricks about learning IR codes to a remote

Quick start guide

1) Put the batteries in
1. Open the cover on the back of the 6 in 1 Universal Remote Control
2. Insert the two CR2032 batteries. Make sure the batteries are NEW.
16-10-2009 3 033000=15299