Sony SNT-V304 Guide De L'utilisateur page 41

HSR-1/1P/2/2P Settings
On the "Administration overview" page, select the
"HSR" icon first, and then the "SETUP" icon to make
settings on the SETUP MENU page. Items not
mentioned below should be set according to the
operating environment.
Alarm Input Settings
Refer to the HSR-1/1P/2/2P Users Guide for details of
HSR-1/1P/2/2P alarm input settings.
Alarm Output Setting
Setting
REMORT PARALLEL
CONTROL OUTPUT
PARALLEL
OUTPUT VOLTAGE
Monitor Display Switching Setting
Setting
IMAGE CONTROL A IMAGE ALARM CHANGE ON
Value
OUT 1 (pin 15) ALARM
OUT 1 (pin 15) 12 V
Value
Video Network Station Settings
On the "Administration overview" page, select
[Application] with the "Layout and Application
Wizard" (page 13), and set the following items. Items
not mentioned below should be set according to the
operating environment.
Setting Value
Alarm pop-up window Disable When set to [Enable], two
Switch image when Disable Because the HSR-1/1P/2/
Alarm ON
Input 1 Alarm On
Enabled
Alarm On at: Off
Positive edge
Alarm On at: On
Negative edge
Number of 0
pre-alarm
images
z Hint
• To ensure recording of images before an alarm event,
on the "Administration overview" page, select the
[HSR] icon first, and then the [SETUP] icon and set
the "RECORDING MODE" to [PRE-ALARM] on
the "RECORDING FUNCTION" page. In this case,
image confirmation is performed at the HSR-1/1P/2/
2P "ALARM SEARCH". Refer to the HSR-1/1P/2/
2P Users Guide for details of HSR-1/1P/2/2P alarm
recording.
• When four video cameras are connected to HSR-1/
1P/2/2P video input terminals 1 to 4 and the HSR
View is set to display four partitions, if an alarm
event occurs at any camera, the number of images set
for the [Number of PRE-Alarm Images] is saved.
However, in this case, the saved image will consist of
the four displayed partitions.
Description
items, an alarm
notification window and
HSR-1/1P/2/2P identifier,
are displayed.
2P switches the image
when an alarm occurs,
this does not need to be
[Enable].
When a number is
entered for the [Number
of Pre-Alarm Images],
images displayed
immediately prior to an
alarm event at the A
terminal of the HSR-1/1P/
2/2P are saved to the
alarm memory of the
video network station.
Therefore, if an image
from another video
camera is displayed
immediately before an
alarm, the required image
is not recorded.
41