THOMSON MIC500IWF Mode D'emploi page 21

Contents
1. INTRODUCTION
2. ITEMS SUPPLIED
3. LOCATION OF CONTROLS
4. REMOTE CONTROL
5. INSTALLATION
6. OPERATION
1. INTRODUCTION
Getting Started
• Remove the appliance from the box.
• Remove any packaging from the product.
• Place the packaging inside the box and either or dispose of safely.
Safety and Notice
Read and understand all instructions before you use this product. If damage is caused by failure to
follow the instructions, the warranty does not apply.
Safety
Warning
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical equipment.
• Keep this apparatus away from direct sunlight, naked Fames or heat.
• Never look into the laser beam inside this apparatus.
• Ensure that you always have easy access to the power cord, plug or adaptor to
disconnect this apparatus from the power.
• Minimum distances 10 cm around the apparatus for sufficient ventilations.
• The ventilation should not be impeded by covering the ventilation openings with
items, such as newspapers, tablecloths, curtains, etc.
• No naked flame sources such as lighted candles should be placed on the apparatus.
• Attention should be drawn to environmental aspects of battery disposal.
• The use of apparatus in moderate climates.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Protect the power cord from being walked on or pinched, particularly at plugs, convenience
receptacles, and the Point where they exit from the apparatus.
10. Only use attachments/accessories specified by the manufacturer.
11. Unplug this apparatus during lightning storms or when unused for long periods of time.
12. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in anyway, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
13. Apparatus shall not be exposed to dripping or splashing.
14. Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles).
1 7. AIR MUSIC CONTROL
3 8. CHARGING
4 9. FEATURES AND TECHNICAL
SPECIFICATIONS
5
10. ABOUT THE DISC
6
11. SERVICE AND SUPPORT
6
- EN 1 -
14
16
17
17
18