Publicité
Les langues disponibles
Les langues disponibles
24 • English
• To avoid cord breakage the cord should only be loosely wrapped
around the cable storage without pulling!
• Do not place the appliance or the cord on hot surfaces e.g.
cooker or similar or in the vicinity of open flames!
• If improper use or misuse or improper repair no liability will be
accepted for damages. In this case no guarantee will be given!
• Chemical waste: a defective appliance should be rendered
unusable. Consult your local authorities for information about
waste disposal regulations.
• Keep packaging material e.g. plastic bags out of the reach of
children!
• The installation of a faulty current protective device with a rated
breaking current offers you additional safety by ensuring that
30 mA will not be exceeded in the house installation. Let your
installation electrician advise you.
› ›
Effectiveness
The foot massager is a comfort for tired, hot or painful feet.
The foot massager eases tense tissue and stimulates the blood
supply. The feet muscles are gently relaxed and the circulation
is stimulated. The foot massager can be used for dry vibratory
foot massage and also with warm water and whirl bath effect.
The vibratory massage eases tense muscles and helps the blood
circulation. The temperatured water - if desired with non-foaming
bath salts - and the powerful whirl effect create a gentle prickling
effect on the skin which calms and relaxes the nerves.
Warning!
Anyone suffering from leg or foot problems e.g. phlebitis, varicose
veins, rash, open sores or other ailments should first consult their
doctor before use.
› ›
Operating›instructions
Unwind the cord from the cord holder of the appliance. The
appliance should be placed on a flat, solid floor. Before filling
with water, ensure that the plug is disconnected from the mains.
Fill the footbath with water at the desired temperature
(max. 3.6 litre, see fig. 1 and b). The water should not exceed
the marking "max". If desired, you can use non-foaming bath
salts in the water.
Arrange a comfortable sitting position and then the appliance can
be connected to the mains.
Always place your feet in the footbath or remove them while
in a sitting position. Never use the appliance in a standing
position or stand up in the unit!
Switching on
The 4-step switch (a) should be turned on and the desired position
chosen:
Step
Functions
0
OFF
1
MASSAGE = vibratory massage for use with and
without water
2
HEAT-WHIRL = heating and whirl bath with water
3
HEAT-WHIRL-MASSAGE = heating, whirl bath and
vibratory massage with water
Heating
A gentle heater has been built underneath the foot rest of the
massager. By switching on the heating it can be avoided that the
warm water cools down quickly. The heater is not suitable for
heating cold water.
25 • English
Functions
Switch setting 1: Vibratory massage with and without
water
For quick use you can have a foot massage without water. Place
your feet - with our without socks - on the bottom of the footbath
and turn the operation switch to setting nr. 1. The heating function
is switched off.
Switch setting 2: Heating with whirl bath massage
The water is ejected through fine holes creating air bubbles which
caress the feet and massage the skin in a gentle way. This is
enjoying and relaxing. The positive effect of the whirl bath can be
increased by the use of a suitable bath oil, however you may only
use non-foaming products. Especially refreshing in warm weather
is the use of the whirl bath with cold water. For all settings with
the whirl bath function the appliance should always be filled with
water.
Switch setting 3: Heating with whirl bath and vibratory
massage
If you chose this function the vibration function and the whirl bath
massage can be simultaneously used. The combination of both has
a positive effect and increases your enjoyment.
Publicité
