Koenic KRVC 2320 RC Mode D'emploi page 27

Troubleshooting, indicated by audible signals of the robot
Voice signal of the robot
The left wheel is hanging in the air
Lead brush is twined
The right wheel is hanging in the air
The left wheel is twined
The right wheel is twined
Because of the uneven ground
The side brushes are twined
The speed sensor is abnormal
The collision sensor is blocked
The dustbin has loosened
The ground sensor is blocked
Work Current detected abnormal
Disposal
Do not dispose of this product as
unsorted municipal waste. Return it to a
designated collection point for the
recycling of WEEE. By doing so, you will help to
conserve resources and protect the
environment. Contact your retailer or local
authorities for more information.
IM_KRVC2320RC_190807_V10_HR.indb 27
Necessary action
Move the robot to a new position and restart the task
Remove dirt (e.g. long hairs) from the brush
Move the robot to a new position and restart the task
Remove dirt (e.g. long hairs) from the wheel
Remove dirt (e.g. long hairs) from the wheel
Move the robot to a new position and restart the task
Remove dirt (e.g. long hairs) from the brushes
Turn off the bottom power switch and restart after 5
minutes. If the fault cannot be discharged, contact your
retailer
Check the collision detection board for damages /
blockages
Ensure that the dust bin is properly fastened to the
robot
Clean the sensor lens and restart it. If the fault cannot
be discharged, contact your retailer
Check the side brushes, wheels and roller brush.
Please dispose of batteries in an
environmentally friendly manner. Do not
put batteries into the household waste.
Please use the return and collection systems in
your community or contact the dealer where you
purchased the product.
English
27
7/8/2019 14:43