Koenic KRVC 2320 RC Mode D'emploi page 24

Size - A5
English
Fig. Insert the water tank into the vacuum
17
robot.
For operation, follow the instructions in
the chapter Operating as a vacuum
cleaner. The robot will automatically
return to the charging base, after the
cleaning process has been finished, or
if the battery level is low. Note, that
the water tank has to be removed
immediately to avoid damages to the
flooring.
Note:
• In order to enhance the wet cleaning result,
it is advised to vacuum the area prior to
the wet cleaning, to remove dust and other
small residues.
• Wet the mop for before each use.
Attention
Water will start to drip out of the
attachment, as soon as the water tank has
been inserted. Start the cleaning process
immediately after inserting the water tank,
so avoid possible damages to the floor. Due
to the same reason, remove the water tank
directly after the cleaning process has ended.
Always supervise the product during the
cleaning, to prevent water damages to the
flooring, in case the robot should get stuck.
The supplier is not liable for damages, that
occur due to the negligence of all given
warnings and remarks concerning the usage
of the product as well as the cleaning of the
flooring.
Fig. After swabbing, remove the water tank
18
with the mop cover.
Fig. Open the rubber cap and pour
19
remaining water out of the tank.
24
IM_KRVC2320RC_190807_V10_HR.indb 24
Fig. Remove the mop cover from the water
20
tank and wash it with a little detergent
and rinse it off. Wring the mop cover
slightly and let it dry.
Fig. Attach the mop cover in the correct
21
position on the water tank. A
replacement mop cover is included.
Recommendations for a better
cleaning result
Vacuuming
• Before starting the vacuuming process,
remove all objects that stand/ lay on the
floor, which could interfere with the process
or in which the robot could get tangled up
(e.g. toys, carpets with longer cords etc.).
• Make sure that no objects hang down onto
the floor, in which the robot could get stuck
(e.g. power supply cables, curtains etc.).
• If possible, place chairs on the table during
the vacuuming process, in order to minimize
the number of obstacles on the floor.
• Block areas, in which the robot could get
stuck (e.g. closets with lowered boards,
tapered areas in between closets etc.).
• Make sure that all brushes can rotate freely
and aren't blocked. Clean them if necessary.
• Empty the dust container.
Swabbing
• Observe all recommendations listed above.
• Have the robot vacuum the area before
swabbing, in order to reduce the amount of
dust on the floor.
• Soak the cleaning cloth under running water
and slightly wring it out, before attaching it
to the water tank, to enhance the cleaning
result and to achieve an equal distribution
of water onto the floor.
• If necessary, pause the swabbing process
and manually wring out the cleaning cloth,
removing bigger particles, before continuing
the process.
7/8/2019 14:43