Installing Batteries In The Remote Control; External Connection - Hyundai HY-TVS50UH-001 Guide D'utilisation

General Description

Installing Batteries in the Remote Control

Installing Batteries
Open the battery compartment
1
cover on the back side.
Insert two 1.5V AAA size batteries
2
in correct polarity. Don´t mix old or
used batteries with new ones.
3
Closed the cover.
NOTES:
• One loading of batteries will last for 1 year under normal use.
• If you do not intend to use the remote controller for a long period of time, remove them
to avoid damage due to leskage.
• Do not use old and new batteries together.
• The batteries (battery pack or batteries installed) shall not exposed to excessive heat
such as sunshine, fire or the like.

External Connection

Antenna connection
Antenna input impedance of this unit is 75ohm. VHF/UHF 75ohm coaxial cable can be connected
to the antenna jack directly, if the antenna cable is 300ohm parallel flat feeder cable, you need to
use the 300ohm/75ohm converter to connect the antenna cable to the antenna jack. For details
Please refer to the following drawing.
Antennas with 300
Use a 75ohm - 300ohm converter
300ohm coaxial cable
flat twins Leads
Antenna feeder
Point the remote towards the remote control
sensor of the TV and use it within 8 meters.
Put the used batteries into the recycling bin
since they can negatively affect the
environment.
Antennas with 75 Round Leads
75ohm coaxial cable
16
Antenna cable