Publicité
Les langues disponibles
Les langues disponibles
Dear Customer,
Thank you for purchasing this Hendi appliance. Please read this manual carefully before connecting the
appliance in order to prevent damage due to incorrect use. Read the safety regulations in particular very
carefully.
Safety regulations
• Incorrect operation and improper use of the ap-
pliance can seriously damage the appliance and
injure users.
• The appliance may only be used for the purpose
for which it was intended and designed. The man-
ufacturer is not liable for any damage caused by
incorrect operation and improper use.
• Keep the appliance and electrical plug away from
water and any other liquids. In the unlikely event
that the appliance should fall into water, imme-
diately pull the plug out of the socket and have
the appliance checked by a certified technician.
Not following these instructions could give rise to
life-threatening situations.
• Never try to open the casing of the appliance your-
self.
• Do not insert any objects in the casing of the ap-
pliance.
• Do not touch the plug with wet or damp hands.
• Regularly check the plug and cord for any damage.
Should the plug or cord be damaged have it/them
repaired by a certified repair company.
Special safety regulations
• Do not insert any objects into the air intake or ex-
haust. (risk of electric shock).
• Do not cover the appliance. (risk of overheating).
Installation
Note: Installation should be performed by a profes-
sional installer or electrician.
1) Drill four holes (ø 8 mm) in the wall (for position of
the holes check Illustration 1 and 2). Put the wall
plugs into the holes
2) Remove the two screws that keep the cover in
place and remove the cover. (Illustration 3)
• Do not use the appliance after it has fallen or is
damaged in any other way. Have it checked and re-
paired, if necessary, by a certified repair company.
• Do not try to repair the appliance yourself. This
could give rise to life-threatening situations.
• Make sure the cord does not come in contact with
sharp or hot objects and keep it away from open
fire. To pull the plug out of the socket, always pull
on the plug and not on the cord.
• Make sure that no one can accidentally pull the
cord (or extension cord) loose or trip over the cord.
• Always pull the plug out of the socket before
cleaning.
• Warning! As long as the plug is in the socket the
appliance is connected to the power source.
• Never carry the appliance by the cord.
• Do not use any extra devices that are not supplied
along with the appliance.
• Only connect the appliance to an electrical outlet
with the Voltage and frequency mentioned on the
appliance label.
• The electrical installation must comply with the
applicable national and local regulations.
• Do not block the exhaust. (risk of triggering the
thermal fuse).
• Do not allow contact with liquids. (risk of short-cir-
cuiting).
3) Pull the wires through the hole and fix the appli-
ance to the wall with 4 screws, then connect the
power wire to a power source (the ground wire is
yellow and green). (Illustration 4)
4) Close the cover and secure it with the two screws
from step 2. (Illustration 5)
EN
5
Publicité
