YORKVILLE 100KW Manuel De L'utilisateur page 4

Effects Loop
The Effects Loop can be used to insert signals from external sources such as a Digital
Effects or Equalizers into the signal path. The loop is inserted after the tone and vol-
ume controls. To use the Effects Loop connect the EFX Sen jack to the input of the
equalizer or effects unit. Connect the output of the equalizer or effects unit to the EFX
RTN jack to complete the loop.
Linking Together Multiple Wedges
When the Yorkville 100kw Power Wedge is used with a line level input for stage moni-
tor purposes, it's possible to link together several units by using the inputs on Channel
2. Insert the mixed signal from a mixing console into either of the two phone jacks (on
Channel 2). It is possible to use the remaining phone jack input on Channel 2 as an out-
put to link to another Yorkville 100kw.
Phones
Headphones can be connected to the Yorkville 100kw by inserting a headphone plug
into the Pones jack located on the front panel. While headphones are connected, the
internal speaker is disconnected. Always use stereo headphones. The audio heard
through stereo headphones will be a mono signal separated into the two earpieces.
Power Switch
When the Yorkville 100kw Power Wedge is turned on, the LED beside the power
switch will be illuminated.
2
Please note: that only information being sent to the input of Channel 2 will be linked.
Caution: Always exercise caution when using headphones to avoid permanent hearing loss.
Power @ min. impedance (Watts)
Minimum Impedance (ohms)
Speaker Configuration - LF (Size / Power)
Speaker Configuration - HF (Size / Power)
Line Out (type / configuration)
Line Out Sensitivity (Vrms)
Effects Return Sensitivity (Vrms)
Dimensions (DWH, inches)
Specifications
100
4
115 Watts
Burst Power - 2 cycle
12 inch / 100 Watts
1 inch / 30 Watts
2
Input Channels
XLR, 1/4 inch TRS
Channel 1 - inputs
Volume
Channel 1 - controls
2x 1/4 inch TRS, RCA
Channel 2 - inputs
Volume
Channel 2 - controls
Low, High
Main Tone Controls
ch. 1 XLR=3 Phone=10, ch.2 Phone=75 RCA=150
Input Sensitivity (mV)
1/4 inch / Front (Effects Send)
1
Yes / Front
Effects Loop / Location
1
Power
LED Indicators
Yes / No
Limiter / Switchable
Yes
Headphone Jack
19 x 17 x 19
48 x 43 x 48
Dimensions (DWH, cm)
39 / 17.7
Weight (lbs / kg)