Assembling The Blender; Installation Of The Blender; Using Your Machine; Instructions For Use - Brandt BLE250 Manuel D'instruction

c)

Assembling the Blender

The machine must be unplugged before any assembly and dismantling operations.
1. Place the rubber seal on the edge of the
blades.
2. Insert the blades onto the connector interface.
3. Screw the interface on the lower part of the
glass jar turning it clockwise.
4. Place the ingredients (less than 2 cm in size)
in the glass jar.
5. Close the lid hermetically.
6. Place the assembled jar on the motor unit.
d) Installation of the Blender
 Place the assembled blender on a smooth, stable surface.
 Before plugging the blender in, check that the jar is correctly in place on the motor unit.
This blender is fitted with a safety system which locks the mechanism if the jar is not
correctly fitted.

3) USING YOUR MACHINE

a)

Instructions for Use

Plug the blender into the electric socket.
Adjusting the speed: Select the speed by turning the selection button to "1" or "2" depending
on the consistency of the food you wish to blend. Turn the control button to "0" to turn the
machine off.
Clean/Pulse: To mix using short pulses turn the control button to the left (pulse function) as
often as you wish to obtain the desired mixture. This function can also be used to clean the jar.
To do this, pour water and a drop of washing-up liquid into the blender.
It is possible to add ingredients when the machine is in operation. To do this,
unscrew the measuring cap (1) by turning it anti-clockwise, as in the picture below:
1. Unscrew the measuring cap (1) by turning it anti-clockwise.
2. Add the ingredients to the jar through the lid.
17