Samsung HW-N400 Mode D'emploi page 28

2. Align the Paper Template's Centre Line with
the centre of your TV (if you are mounting
the Wall Mount Guide to the wall using tape.
• If you are not mounting below a TV, place
the Centre Line in the centre of the
installation area.
3. Use a sharp object, such as a pen or pencil, to
mark the holes' positions, and then remove
the Wall mount Guide.
4. Using an appropriately sized drill bit, drill a
hole in the wall at each marking.
• If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the
holes before you insert the support
screws. If you use anchors or mollies,
make sure the holes you drill are large
enough for the anchors or mollies you
use.
Centre Line
the Soundbar below your TV), and then fix
450mm
450mm
5. Push a screw (not supplied) through each
Holder-Screw, and then screw each screw
6. Install the 2 Bracket-Wall Mounts in the
correct orientation on the bottom of the
Soundbar using 2 Screws.
• When assembling, make sure the hanger
part of the Bracket-Wall Mounts are
located behind the rear of the Soundbar.
ENG - 24
Right end of Soundbar
firmly into a support screw hole.
Rear of Soundbar