Publicité
Les langues disponibles
Les langues disponibles
• Alternatively, you can charge the headset using a
suitable USB charger. Please refer to the operating
instructions for the USB charger used.
• The function LED is constantly lit red during charging.
• It takes around 4 hours until the battery is completely
charged.
• Once the charging process is complete, the indicator
LED goes out.
• Disconnect all cable and mains connections after use.
5. Operation
5.1 Bluetooth pairing
Note – Pairing
• Make sure that your Bluetooth-capable terminal
device is on and Bluetooth is activated.
• Make sure that your Bluetooth-capable terminal
device is visible for other Bluetooth devices.
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should be no
further than 1 metre apart. The shorter the distance,
the better.
• Make sure that the headset is fully charged and
switched off.
• Press and hold the multifunction button (4) for about
2 seconds to turn the headset on. It automatically
enters pairing mode. The function LED emits flashes of
alternating red and blue light. The headset is searching
for a Bluetooth connection.
• Open the Bluetooth settings on your terminal device
and wait until "WHP-6007" appears in the list of
Bluetooth devices found.
• Select "WHP-6007" and wait until the headset is
listed as connected in the Bluetooth settings on your
terminal device.
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection to the headset, enter 0000.
Note
• If pairing is successful, a beep will sound and the
LED indicator is constantly lit blue.
• If pairing is not successful, the indicator remains con-
stantly lit, and you will have to perform pairing again.
• If pairing takes longer than 90 seconds, the
headset switches off automatically.
• If this happens, you will need to switch the headset
off and on again if you want to pair it with your
terminal device again.
• On some terminal devices, such as PCs, you will need
to select the headset from the pairing list after pair-
ing and confirm you wish to 'use as audio device'.
• You can now use the headset.
5.2. Automatic Bluetooth connection (after
successful pairing)
• Make sure that the headset is switched on.
• Press the multifunction button (4) to automatically
connect the headset with your terminal device.
• You can now use the headset.
Note – Connection impaired
If the Bluetooth connection is not established auto-
matically, check the following:
• Check the Bluetooth settings of your terminal device
to see whether "WHP-6007" is connected. If not, re-
peat the steps listed under 5.1. Bluetooth pairing.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
• The performance can also be affected by a weak
battery.
3
Publicité
