Battery removal Instructions
iMportant
Contains sealed, non-spillable lead-acid
battery. Must be disposed of properly.
Battery removal and Disposal
The battery inside this Booster Pack is a sealed
lead-acid battery. By LAW, it is required to be
removed and recycled or disposed of properly.
While there are federal regulations that must be
complied with throughout the United States, your
individual state or local governments may have
additional regulations to be followed in your area.
Booster pack Battery removal/
replacement
If Booster Pack battery is replaced, you must take it
to your local recycling center for proper recycling for
disposal. If you don't have a local recycling center
that handles sealed lead-acid batteries, contact your
local environmental agency for instructions.
Battery removal
1. Lay the Booster Pack down on its front.
2. Loosen all screws on the back side that hold the
Booster Pack case together.
PeAk
AmP
model no.
RATIng
mjS1500
Booster Pack
1500
replacement parts available:
MJS1500
CRAnk
ASSIST
AmP RATIng
350
RSPS151 110V AC power cord
RSPS152 12V Accessory Power Cord
RSJSB02 Replacement Battery MJS1500
RSJSBCCS Cables/Clamps Set
3. Open the back half of the Booster Pack case.
4. Loosen the screws to separate the booster cables
from the battery.
noTe: To prevent accidental arcing, be careful not to
touch both battery terminals with the tools being
used to remove the bolts.
noTe: Once the battery is removed, wrap its
battery terminals with electrical tape to prevent
accidental shorting.
5. Change the battery, then tighten the booster
cables on the new battery.
noTe: When reconnecting the wires to the battery
terminals, remember that the red wires connect to
the positive (+) battery terminal and the black wires
connect to the negative (-) battery terminal.
6. Close the back side cover and tighten all screws.
ClAmP
CABle
AmP
gAuge
RATIng
4
500
5
BATTeRy
STATuS
ACCeSSoRIeS InCluded
led
Power extension
lights
cord (double male
show
cigarette lighter
charge
ends), 110v AC
power cord
08/20/08