Ndustrio 090VTR Manuel D'utilisation Et D'installation page 24

Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
A)Auto-resetting thermostat: each heating ele-
ment is equipped with this device, which halves
its power output in case of overheating. Once the
problem has been resolved and the temperature
has returned to normal, operation is automatical-
ly restored.
The illustration shows the position of the signs pro-
vided.
A)Nameplate with manufacturer and appliance
data.
B)Burn hazard: watch out for hot surfaces.
C)General hazard: when washing the appli-
ance do not point pressurised water jets at
internal parts.
D)General hazard: read the manual carefully
before carrying out any procedure.
E)General hazard: all relevant regulations must be
complied with. "Install in compliance with the rel-
evant regulations and use in well ventilated
IT IT
premises only".
F) General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of
GB GB
failure to comply with the installation and com-
missioning instructions".
DE DE
G)CE marking: indicates that the appliance is com-
pliant with the relevant norms.
FR FR
H)WEEE symbol: indicates that the appliance is
subject to specific waste disposal regulations.
ES
ES
The appliance can be equipped with the following
accessories on request.
A)"Over cupboard" installation kit (see14)
B)"Bridge" installation kit (see page 14)
C)Supporting beam kit (see page 14)
English
SAFETY DEVICES
SAFETY AND INFORMATION SIGNS
OPTIONAL ACCESSORIES
Important
There are no indicator devices to signal
that the thermostat has been tripped
Caution - warning
Make a daily check that the safety devices are
properly installed and in good working order.
H
- 4 -
F
E
G
A
C
B
D