Avoiding Traffic Event On The Route; Cancelling The Rds-Tmc Voice; Receiving Rds-Tmc Stations; Manually - Sony NVX-HC1 Mode D'emploi

A Traffic events and distance
B Detailed information*
C Road name
D Distance influenced by the traffic event
E Page count on the information*
F Starting point of the traffic event
G Closing point of the traffic event
* Appears when available. You can check the
detailed information by rotating the R dial on the
main unit or pressing < or , (M or m) on the
remote commander to display the next or
previous page.
Traffic event
Stationary
traffic
Traffic jam
Accidents
Closed road
Road works
Danger
To display all traffic information currently
available (including the information on other
routes), press (MENU), then select "RDS-TMC
Information" c "All Traffic Conditions" c the
desired road.
Tip
You can also display traffic information by pressing
(MENU), then select "RDS-TMC Information" c
"Traffic On Route" by <, ,, M, m and (ENTER).
Avoiding traffic event on the
route
The system offers dynamic route guidance for
calculating an alternative route to avoid traffic
event.
When traffic event occurs, the confirmation
display appears.
A B
18
A Traffic event
B Additional distance caused by detour*
* May be shortened depending on the calculated
1
Select "OK" when avoiding the traffic
event by <, , and (ENTER).
To cancel avoiding the traffic event, press
(MENU), then select "RDS-TMC Information"
c "Dynamic Navigation" c "Off" by <, ,, M,
m and (ENTER).
Road
conditions
Cancelling the RDS-TMC
Weather
voice guidance
Delays
You can cancel providing the voice guidance so
as not to interrupt the radio, CD, etc.
Parking
1
Press (MENU).
2
Select "RDS-TMC Information" c
Out of order
"Guide" by <, ,, M, m and (ENTER).
3
Select "Off" by M, m and (ENTER).

Receiving RDS-TMC stations

manually

The system receives TMC stations in the area
automatically even after crossing the border.
If the RDS-TMC reception is poor, you can
specify the country and receive TMC stations
manually.
1
Press (MENU).
2
Select "RDS-TMC Information" c
"RDS-TMC Setup" c "Station" c
"Manual" by <, ,, M, m and
(ENTER).
The RDS-TMC station list appears.
3
Select the desired station by M, m and
(ENTER).
To specify your area, select "Country" instead of
"Station" in step 2, then select the desired area.
Note
It may take a few minutes to receive the RDS-TMC
station list.
alternative route. Displayed with a minus sign in
this case.