KUKKO 56 Mode D'emploi page 3

Operation instruction for Hydraulic Nut Splitters 56-1 und 56-2
A
1. With chisle (B) in starting position, turn screw of anvil (A) to squeeze opposite nut flats bet-
ween the chisle and anvil (see illustration).
2.+3.Tighten thrust screw (C) slowly to split the nut, stopping the process briefly to build up full
hydraulic pressure should be too low, back off thrust screw (C), advance anvil (A), and
retighten thrust screw.
4. The maximum capacity will be reached at a torque of
DO NOt ExCEED tHESE vAlUES tO prEvENt ACCIDENtS AND DEStrUCtION Of
tHE tOOl!
Note:
Service conditions require the flat configuration of these splitters, which excludes the
provision of the chisle with a spring-loaded rest system. The chisle must, therefore, each time
be pushed back by hand, as described below:
1. Back off thrust screw (C).
2. Use some kind of spacer between chisle (B) and anvil (A) and tighten the latter to push
chisle back into starting position.
KUKKO 56
B
Spare part
normal operation
max. capacity
60 Nm for 56-1
70 Nm for 56-2
Wear eyeprotection
space-saving operation
60 Nm for 56-1
C
70 Nm for 56-2.
and