Modellsport MULTIPLEX A-Sensor 150 A Instructions page 9

Type / Typ (= type)
Max value, Min value, Average /
Maximalwert, Minimalwert, Mittelwert
(= maximum value, minimum value or average),
in each case in A
Power on delay / Wartezeit nach Einschalten
(= period after switching ON after which the
measurement commences)
Period
in the range 0 to 3 seconds
Charge Q / Ladung Q (= charge)
Address / Adresse (= address)
off / aus (= off), or an address
in the range 0 to 15
Display / Anzeige in
(= display in charge quantity or %)
select facility mAh or %
Capacity / Akkukapazität
(= nominal capacity of the connected battery)
in the range 0 mAh to 16000 mAh
Alarm at / Alarm bei
(= what is the residual charge value at which the alarm is to be
triggered?)
off / aus (= off), or a value
in the range 0 mAh to 16000 mAh or
in the range 0% to 100%
Send / Senden (= send data)
click on-screen button to send the data
Factory Set. / Werkseinst. (= reset to default setting)
click button to reset the values to the default settings
Reset / Reset (= reset option values)
click on-screen button to erase the option values
Exit / Beenden (= finish)
click on-screen button to close the view
12. S
WITCHING THE
1. Pre-flight
Switch the transmitter ON.
If the receiver power supply is drawn from one or more separate
receiver batteries: switch the receiving system ON.
Connect the flight battery.
Caution: motor may start – injury hazard!
! Tip: if you are using a freshly charged flight battery for the
next flight, press the RESET button on the top of the current sen-
sor now in order to reset the "fuel gauge" and any option values.
2. Post-flight
Disconnect the flight battery.
If the receiver power supply is drawn from one or more separate
receiver batteries: switch the receiving system OFF.
Switch the transmitter OFF.
13. G / L
UARANTEE
The company MULTIPLEX Modellsport GmbH & Co.KG accepts
no liability of any kind for loss, damage or costs which are due to
the incorrect use and operation of this product, or which are
connected with such operation in any way. Unless the law
expressly states otherwise, the liability on the part of MULTIPLEX
Modellsport GmbH & Co.KG to pay damages, regardless of the
legal argument employed, is limited to the invoice value of those
products supplied by MULTIPLEX Modellsport GmbH & Co.KG
which were directly involved in the event in which the damage
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions for the
Current Sensor for M-LINK receivers (150 A)
RC ON / OFF
SYSTEM
IABILITY EXCLUSION
occurred. This does not apply if liability is incurred according to
statutory law on account of intentional or gross negligence.
We guarantee our products in accordance with the currently valid
statutory regulations. If you wish to make a claim under
guarantee, your initial course of action should always be to
contact the dealer from whom you purchased the equipment.
The guarantee does not cover faults and malfunctions which are
caused by the following:
Incorrect or incompetent use
Maintenance carried out incorrectly, belatedly or not at all, or
not carried out by an authorised Service Centre
Incorrect connections
The use of accessories other than genuine MULTIPLEX items
Modifications or repairs which were not carried out by
MULTIPLEX or by an authorised MULTIPLEX Service Centre
Accidental or intentional damage
Defects due to normal wear and tear
Operation of the unit outside the limits stated in the
Specification
Operation of the unit in conjunction with equipment made by
other manufacturers.
14. CE
CONFORMITY DECLARATION
This device has been assessed and approved in accor-
dance with European harmonised directives.
This means that you possess a product whose design and
construction fulfil the protective aims of the European Community
designed to ensure the safe operation of equipment.
If necessary, the CE conformity declaration for the device can be
requested from MULTIPLEX using the contact data in the footer.
15. D
ISPOSAL NOTES
Electrical equipment marked with the cancelled waste
bin symbol must not be discarded in the standard
household waste; instead it should be taken to a
suitable specialist disposal system.
In the countries of the EU (European Union) electrical
equipment must not be discarded via the normal
domestic refuse system (WEEE - Waste of Electrical and
Electronic Equipment, Directive 2002/96/EG). You can take
unwanted equipment to your nearest local authority waste
collection point or recycling centre. There the equipment will be
disposed of correctly and at no cost to you.
By returning your unwanted equipment you can make an impor-
tant contribution to the protection of the environment!
Page 4/4