Toolson DWS225BT Traduction De La Notice Originale page 20

Storage and transport
1. Whenever you do not use the power tool, you must
keep it in a dry and weil ventilated place out of the
reach of children, e.g. on a high cabinet or in a
closed place.
2. Keep power tool, instruction manual and accesso-
ry parts, if any, together in the original packaging,
if possible. Thus you have all information and parts
available at any time.
3. Always hold the power tool by its handle.
4. To avoid transport damages, you must pack the po-
wer tool or use the original packaging.
5. Protect the power tool against vibrations and shock,
especially during transport in vehicles.
Troubleshooting
Supposed malfunctions, errors or damages are often caused by events which can be remedied by the operator. Therefore
check the power tool on the basis of the following table before you contact a specialist. Many malfunctions may thus be re-
medied.
Problem Possible cause
1. Power tool does not Power supply interrupted
start
Power cord or plug defective
Other electrical defect of the power tool
2. Power tool does Extension cord too long and/or cross-
not operate with full section too small
power
Power supply (e.g. generator) voltage
too low
3. Poor operation Power tool worn out
results
Grinding plate worn out
4. Considerable dust Brush edge worn out
formation
Dust extraction not connectred /
switched on
20 І 160
Approach
Check power supply by connecting another power tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cord with permissible length and/or
adequate cross-section
Connect power tool to an appropriate power supply
Replace insertion tool
Have grinding plate replaced
Have brush edge replaced
Connect / switch dust extraction