Installation Instructions - Tylo 2900 2365 Notice D'installation Et D'emploi

5. Installation instructions

Fig. 1. Fit the yellow suction hose to the snap connector by pressing it inwards until it stops. Cut the hose if necessary to fit the
fragrance holder. Cut at an angle so that the bottom of the holder cannot constrict the hose. The hose must reach down to the
bottom of the can.
Fig. 2. Fit the pump on the fragrance holder:
Unscrew the lid of the fragrance holder, and screw on the pump. Hold the pump with one hand. Screw the pump on clockwise with
your other hand until it is securely mounted on the fragrance holder. The pump can still rotate in the desired direction even when
screwed onto the fragrance holder.
If the adapter supplied is needed for a 10L or smaller fragrance holder, screw the adapter onto the pump first, and then the pump
onto the fragrance holder.
Suction hose
(yellow)
Fig. 3. Fit the green feed hose:
Install the snap connector supplied at a suitable point on the steam pipe. NB: The distance between feed hose and steam pipe must
be min. 10cm! The connection to the steam pipe must not allow the essence to run back into the steam generator tank.
Fit one end of the green feed hose to the pump snap connector.
Fit the other end of the green feed hose in the snap connector mounted on the steam pipe.
Fig. 4. Fit the thermostat at a suitable point on the steam pipe using the cable tie supplied.
Thermostat
Steam pipe
Adapter
Feed hose (green)
Max 1m
6
Snap connector
Steam pipe
Min.
10cm