Menu And Settings; Maintenance; Rohs (Restriction Of Hazardous Substances) - Tylo 2900 2365 Notice D'installation Et D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15

7.1 Menu and settings

When the power cord is connected to the pump, the LCD display will show the pump software version for under 2 sec.
The pump is factory set to "Continuous Feed". This means that the pump will run continuously as long as it is controlled via the
signal cable. Pump and pause times can be set as follows: Pump time 0.1 → 9.9s or "Continuous Feed". Pause time 1 → 60min.
See settings below.
1.
Press menu. The menu will show "Adjust Feed?". Press "OK".
2.
The menu will show "Set run time". Use the arrow keys to increase or decrease pump time to the desired value. Press
"OK".
3.
The menu shows "Set pause time". Use the arrow keys to increase or decrease pause time between pumpings. Press
"OK".
Note:
If setting the pump time to less than 0.1 sec., set pump to "Continuous Feed".
This means that the pump will ignore the set pump/pause times and will only react to the signal cable.
The following two criteria must be fulfilled simultaneously for pumping.
1.
Steam pipe temperature must exceed 70°C
2.
The pump must be activated via the signal cable 230V (steam generator calls for fragrance)
Notes ref. pump program in use:
If the temperature on the steam pipe drops (no steam) below +70°C, the pump will stop immediately. "No Steam" will appear on the
display.
If there is no current on the signal cable (steam generator switched off), the pump will go to the end of its cycle and shut down.
7.2 Menu flow
"Menu"
<Main menu display>

8. Maintenance

Check that there is fragrance in the holder regularly. Replace or fill up the holder with new fragrance as required. NB: pump/pause
times will require adjustment after a power outage.
Check the pump regularly for correct operation. If the pump is not pumping fragrance properly, check that the power cord is securely
connected and that the thermostat on the steam pipe is correctly placed. Also check that the signal cable 230VAC is correctly
connected to the steam generator.
9. ROHS: (RESTRICTION OF HAZARDOUS SUBSTANCES)
Instructions for environmental protection. Do not dispose of this product with the domestic refuse when no
longer in use. Take it to a recycling station for electrical and electronic equipment.
For further information, see the symbol on the product, manual or packaging.
The different materials can be recycled as specified by their labelling. You can help protect the environment by
recycling or reusing spent appliances or the materials in them. Take the product to a recycling centre. Please
contact your local authorities for details of your nearest recycling centre.
"OK"
ADJUST FEED?
"C"
8
SET RUN TIME
xx s
"C"
"OK"
SET PAUSE TIME
"C"
xx min
"OK"

Publicité

Table des Matières
loading

Table des Matières