D-Link DCS-2670L Mode D'emploi page 5

mOuNTiNG THE CAmErA
DCS-2670l
Step 3:
Place the baseplate over the holes that are in the
wall. Make sure to align the baseplate holes with the
holes in the wall. Use the supplied screws to attach
the baseplate to the surface of the wall.
Step 4:
Place the camera over the baseplate and align the
nub with the hole on the camera. Attach the camera
by sliding it in the direction of the arrow. Then screw
the baseplate to the camera body.
Step 5:
Once the camera is secured to the baseplate, use a
screwdriver to fasten the screw next to the hole at the
back of the camera body.
Step 6:
Adjust the angles via the camera body and rotate the
silver base until you achieve your desired viewing
angle.
5