Installation; General - Hatco KGRDE Série Mode D'emploi

INSTALLATION

General

Electric Griddles are shipped with most components installed
and ready for operation. Care should be taken when unpacking
the shipping carton to avoid damage to the unit. The following
installation procedure must be performed before connecting
electricity and operating the unit.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
maximum of 104°F (40°C).
FIRE HAZARD:
• Do not install unit above or around combustible
surfaces. Discoloration or combustion could occur.
Unit must be installed in non-combustible surroundings
only.
• Allow a minimum clearance of 1" (25 mm) along
the sides and rear of unit. If safe distances are not
maintained, discoloration or combustion could occur.
• Do not obstruct air ventilation openings on unit. Unit
combustion or malfunction may occur.
1. Inspect the shipping carton for obvious signs of transit
damage. If damaged, inform the freight company
immediately. CAUTION! Stop! Do not attempt to use
unit if damaged. Contact Hatco for assistance.
2. Remove the unit and any loose components/accessories
from the shipping carton. The following loose components
are included in every Electric Griddle:
• Legs
• Drip Tray
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces
of the unit.
• Make sure to remove all protective film from the stainless
steel surfaces.
4. Inspect the unit for freight damage such as dents in
housing or broken knobs. If damaged, inform the freight
company immediately.
5. Install the included legs.
a. Carefully tip the unit backwards and rest it on top of
cardboard on a flat surface.
b. At each corner, thread a leg into the bottom of the unit.
Hand-tighten until snug. Do not over-tighten.
c. Return the unit to the upright position.
NOTE: The feet on the legs are adjustable for leveling the unit.
Make leveling adjustments once the unit is placed in its
final position.
Leg
Adjustable Foot
Installing the Legs
Locate unit at proper counter height in an area that is
convenient for use. Location should be level and strong
enough to support weight of unit and contents.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures and grease could cause damage to unit.
Damage to any countertop material caused by heat
generated from this equipment is not covered under the
Hatco warranty. Contact manufacturer of countertop
material for application information.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a maximum of 104°F
(40°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
7. Make sure the drip tray is installed on the front edge of
the unit. Make sure the peg on each tray handle is seated
securely in the notches on the griddle frame.
Installing the Drip Tray
6
English
CAUTION
NOTICE
Peg
Drip Tray
Tray Handle
Form No. KGRDEM-0120
Notch