Bertos 600 Série Mode D'emploi page 37

diagrams at the end of the manual. The chosen
connection cable must have features similar to the
H07RN-F type with an operating temperature of at
least 80°C and have a section suitable to the unit (see
technical data on the tables).
4) Pass the cable through the passage and tighten
the cable stopper, connect the conductors in their
corresponding position to the terminal board and fix
them. The yellow-green ground conductor must be
longer than the others so that in the event that the
cable stopper breaks, it disconnects itself after the
voltage cables.
Equipotential
The appliance must be connected to an equipotential
system. The connection terminal is positioned close to the
supply cable input.
It is marked by the symbol:
Attention!
The manufacturer is not responsible and will not
reimburse, under guarantee, damages due to improper
installation and installation which does not conform
with these instructions.
APPLIANCE TEST
Important
Before putting in operation, test the equipment
to evaluate the operational conditions of each
component and single out any possible anomalies.
During this phase, it is important that safety and
hygiene conditions are strictly followed.
Carry out the following controls to perform the test:
1) check that the mains voltage is in conformity with the
appliance voltage
2) use the automatic isolator switch to check the
electrical connection
3) check the proper operation of safety devices
After testing, if necessary, train the users in order that they
understand all necessary skills in order to operate the
equipment in safe conditions, according to the regulations
in force in the country in which the equipment is to be
used.
USE INSTRUCTIONS
ATTENTION !
Use the appliances under supervision and never
operate whilst empty.
Lights indicate if every unit is on or off.
The appliance does not need particular adjustment
interventions by specialized persons except for the
regulations made during the operation by the user.
Use only the accessories recommended by the
manufacturer.
The appliances are designed to cook directly on the
griddle. Do not use the appliances to cook food using
pans or other containers.
For better performance
consumption, defrost frozen food at room temperature
before cooking.
During the initial uses of the appliance, an acrid or
burning smell may be detected. This will disappear
after two or three uses.
After use, the areas are hot for a certain amount of
time (residual heat). Do not rest your hands and keep
children away from them !
These are very important regulations, if they are
neglected, the appliance may not perform properly or
the user may be placed at risk.
This appliance cannot be used by people (including
children) with impaired skills or without experience
and knowledge unless under the supervision of a
person responsible for their safety who provides
precise instructions about the use of the unit.
Keep children under supervision to make sure that
they don't play with the unit.
GRIDDLE OPERATION STEEL PLATE
Initial use of the griddle
Important!
Before using the unit for the first time, clean the surface
properly with warm water and detergent and use a soft
cloth to eliminate all traces of anti-rust applied in the
workshop; dry with a clean cloth (see the paragraph "Care
of the appliance").
Make sure the gravy collecting tray is positioned correctly.
Activate the main switch before the appliance.
Before switching on the unit, rotate the handle from
the position / to the desired temperature included
between 50°C and 300°C; the lights will switch on: the
green light indicates the unit is under operation, the
orange light indicates the heating elements are working.
As soon as the desired temperature is reached, the orange
light will switch off.
The whole griddle area is heated.
The models with double griddles are equipped with
two cooking areas with separate controls to adjust
temperature independently.
| 37
and reduced energy
EN