Installation Requirements; Tools And Parts; Location Requirements - KitchenAid KEWS175BPA Instructions D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Phillips screwdriver

Drill

1³⁄₈" (3.5 cm) hole saw

Parts supplied

4 - #8-18 x ⁵⁄₈" screws

Lens (for panel ready models)

Check local codes. Check existing electrical supply. See

"Electrical Requirements."

It is recommended that all electrical connections be made by a

licensed, qualified electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cutout dimensions that are shown must be used. Given

dimensions provide minimum clearance with warming drawer.

Recessed installation area must provide complete enclosure

around the recessed portion of the warming drawer.

Grounded electrical supply is required. See "Electrical

Requirements" section.

Electrical supply outlet should be located in the rear wall on

the upper right-hand side of the cutout or in an adjacent

cabinet. The outlet must be recessed. If the electrical outlet is

located in an adjacent cabinet, a 1³⁄₈" (3.5 cm) minimum

diameter hole should have been drilled in the back of the

cutout or support surface to pass the power supply cord

through to the outlet.

Warming drawer support surface must be solid, level and

flush with bottom of cabinet cutout.

For best performance results, make sure the warming drawer is

leveled before completing installation. There is no way to level the

warming drawer after it has been installed. If the installation is not

level, the door may slide open or not seal tightly, allowing heat to

escape.

NOTE: If installing the warming drawer below another product,

refer to that product's literature for any installation requirements.