Stopping; Operation Instructions; Integration Into An Exixting Electricity Grid - Zipper ZI-STE3000L Mode D'emploi

For cold start you must close the choker, for warm start
you must open it.
Turn ON the engine switch.
Start the machine by pulling the starter handle.
When the choker is closed you must open it when the
engine is runned warm.
16.6

Stopping

Turn off connected devices and disconnect them with the generator.
Turn OFF the engine switch.
Close the fuel valve.
17

OPERATION INSTRUCTIONS

17.1

Integration into an exixting electricity grid

This power unit is designed exclusively for operating electric devices whose max. Performance
within the performance specifications of the generator. A higher starting current of inductive
loads must be considered.
The generator is designed to operate from conventional resistive and inductive loads, such as
Lights, electric hand tools (drills, electric chain saws, compressors) determined.
When connected to stationary systems such as heating, electrical supply, air condition-
ing systems or for the power supply of mobile homes, is regarding the connection and
the ground to draw necessarily a qualified electrician and the heater manufacturer for
advice.
Failure to comply with the provisions of the general regulations and the provisions of this manual,
the manufacturer for damages can not be held responsible.
By the manufacturer, the protection measure ˝ protective separation is provided with equipoten-
tial ˝ and installed.
Z.I.P.P.E.R Maschinen Austria www.Zipper-maschinen.at
OPERATION INSTRUCTIONS
Stromerzeuger / Generator ZI-STE3000L
Seite 36